Desciption rubber sheet is essential to improve conveyor belt performance. It is used to reduce belt slippage, improve tracking and extend life of belt, bearing and other components. Ceramic Pulley Lagging is specially suited for pulleys where slippage and excessive wear and tear problems make normal rubber lagging ineffective. The ceramic tiles help in proper grip of the belt under wet, muddy or any other such arduous conditions.
1. Desciption
rubber sheet is essential to improve conveyor belt performance.
It is used to reduce belt slippage, improve tracking and extend life of belt, bearing and other components.
Ceramic Pulley Lagging is specially suited for pulleys where slippage and excessive wear and tear problems make normal rubber lagging ineffective. The ceramic tiles help in proper grip of the belt under wet, muddy or any other such arduous conditions.
2.Features of ceramic pulley lagging:
1.Aluminum Oxide:92%.
2.Ceramic Hardness(Mohs):>9t
3.Working temperature:≤85°C
4.Rubber Hardness: 60±5 Shore A
5.Tensile strength:15 MPa
6.With CN bonding layer or as request.
3.Installation of ceramic pulley lagging
Ceramic pulley lagging is suitable for pulleys performing in the most difficult conditions.
It can be installed through cold vulcanization process on site or at pulley manufacturer.
4. Sizes of ceramic pulley lagging:
Thickness: 12mm, 15mm
Width: 200mm, 500mm
Length: 450mm to 2300mm
Roller Major technical parameters:
Roller resistance to rotation
Diameter of carrier roller mm |
Length of carrier roller mm |
Resistance to rotation N |
|
φ76 |
non-contact seal |
≤460 |
2.0 |
>460 |
2.5 |
||
φ89 |
non-contact seal |
≤460 |
2.5 |
>460 |
3.0 |
||
φ108 |
non-contact seal |
≤800 |
3.0 |
>800 |
3.5 |
||
φ133 |
non-contact seal |
≤800 |
3.0 |
>800 |
3.5 |
||
φ159 |
non-contact seal |
≤800 |
3.0 |
>800 |
3.5 |
The amount of radial run-out
Diameter of carrier roller mm |
Length of carrier roller mm |
||
<460 |
460-950 |
>950-1600 |
|
φ76—φ108 |
0.5 |
0.7 |
1.30 |
φ133—φ159 |
0.7 |
1.00 |
1.50 |
Roller Axial load
Diameter of axle of carrier roller |
Imposed axial load KN |
≤20 |
10 |
≥25 |
15 |